Driver window does not close all the way, well it does, but not really

[Borec Senior Member Find all posts View Profile Close Borec]

Hi all,

I have done something with my window, not sure what, I have taken the battery out and also the door panels in order to clean the dust out of the windows switches and door locks.

First I was alarmed when I could not work out why my other windows do not work from the master control switch, but then I worked it out by trial and error, and later found out that you need to reset the window switches in order for them to operate after the battery is taken out.

However, I still have a problem with my driver’s window, when I close it, it closes all the way, but then it backs down about an inch, no matter what I do. The only way to close it, is to do small interrupted ups until it is nearly closed and then it does not go down again. But if I use “auto” to pull it up, it backs down after it fully closes, and if I just keep the switch up, it backs down after I let the switch go.

Any ideas what I might have done to deserve this?

Thank you for any suggestions.

[RanJ Avid PP Poster! Find all posts View Profile Close RanJ]

Hiya Borec, try rolling it down and holding it down for about 10secs, then roll it up and hold it up for about 10 secs.

Failing that, I would disconnect the battery again and reprogram all the windows again.

[raydes Advanced Member Find all posts View Profile Close raydes]

something is stuck in the rubber, window seal. it does this if you have your fingers stuck in there to,lol

[Borec Senior Member Find all posts View Profile Close Borec]

Ran my fingers through the rubbers and it closes OK now, thanks for the suggestion