I had a Bullbar fitted last week, very happy with my choice of TJM T13 however the Outside temp gauge is now reading higher then the scan gauge Inlet temp. Normally the scan gauge reads (inlet temp) 1-2 degrees above the factory gauge. But after the bullbar was fitted it started to read on average 20-22 degrees. Note ambient would be around the 12-15 degree mark. So I'm thinking the sensor is picking up heat from the engine bay.
Has anyone else found this after fitting a bullbar?
Can anyone point me towards the sensor so I can check its fitting? Maybe its been tucked out of the way during installation of the bar and not been refitted correctly?
Cheers
Pinko
Has anyone else found this after fitting a bullbar?
Can anyone point me towards the sensor so I can check its fitting? Maybe its been tucked out of the way during installation of the bar and not been refitted correctly?
Cheers
Pinko
Comment