I installed a genuine Toyota tow bar to my 150 Prado 5 door today, everything went well and I thought the job was finished until I inserted the hitch tongue into the receiver. It seems that the hole for the locking pin in the tongue is drilled about 10mm too short, therefore preventing the locking pin passing through the tongue.
I have contacted the dealer I purchased the bar though and am waiting a response from them, but I was just curious if anyone has seen this before. The tongue I have is only drilled with 1 hole on one side (obviously the one that is too short) and the hole on the other side appears to be marked by the laser cutter, but not actually cut out.
I have contacted the dealer I purchased the bar though and am waiting a response from them, but I was just curious if anyone has seen this before. The tongue I have is only drilled with 1 hole on one side (obviously the one that is too short) and the hole on the other side appears to be marked by the laser cutter, but not actually cut out.
Comment