Rear Cargo Socket - Trim removal

[Symo Advanced Member Find all posts View Profile Close Symo]

Hi,

I have searched and searched and haven't found too much info regarding the removal of the rear trims on the drivers side of the GXL 150. Can any one provide some info on do's and don'ts or is it a case of start removing stuff from the rear passenger door and head backwards?\

I am planning to run accessories cable down the drivers side from the engine bay, I can get the cable as far as the rear seat then I am stumped.

Many thanks.

[Guest Close Guest]

Use the yellow tongue from tongue and groove flooring panels that electricians use. This will avoid unnecessary removal of the entire trim, just near the entry and exit points.

[mjrandom Out of control poster! Find all posts View Profile Close mjrandom]

You can take the cup holder out and also the 240V socket which gives you some sighting room and possibly a hand hold and then I used a length of 3mm brushcutter cord which is stiff enough to push around things but not so strong that it damages anything. Once you have it routed where you want tape on the cable and use the cord as a pull wire. I didn't remove either the LHS or RHS rear trims.

[Symo Advanced Member Find all posts View Profile Close Symo]

Ok great!

[Symo Advanced Member Find all posts View Profile Close Symo]

Yep easy enough did it today and found some space around the rear aircon unit. Just need to install the sockets.