I hope someone can provide some advice:
I Installed a BCDC1225D in my Prado 2012 VX today and the car no longer starts.
Everything is installed correctly (checked this over and over over again) every termination is correct. All chassis grounds (BCDC and both batteries) are connected to chassis and have continuity (0.2ohms approx including meter leads)
the cranking battery is sitting at 12.5v approx
the aux sitting at 13.8v approx
dash lights and all electrical functions of the vehicle appear to work with acc on however, flashing engine light and 4LO light and if I attempt to start the car just clicks once and starts the acc sequence again.
The redarc has no fault lights displayed and has normal flashing light for the charging profile indicating it’s in standby mode which is normal.
please help if possible!!!?!!?!??
I Installed a BCDC1225D in my Prado 2012 VX today and the car no longer starts.
Everything is installed correctly (checked this over and over over again) every termination is correct. All chassis grounds (BCDC and both batteries) are connected to chassis and have continuity (0.2ohms approx including meter leads)
the cranking battery is sitting at 12.5v approx
the aux sitting at 13.8v approx
dash lights and all electrical functions of the vehicle appear to work with acc on however, flashing engine light and 4LO light and if I attempt to start the car just clicks once and starts the acc sequence again.
The redarc has no fault lights displayed and has normal flashing light for the charging profile indicating it’s in standby mode which is normal.
please help if possible!!!?!!?!??
Comment